11/25/2023 0 Comments Festool parallel guideIf you install the Parallel EDGE Guide upside down from its normal position, the outer guide is the correct height to ride along the surface of the off cut material and may prove to be a better method to stabilize your saw during this bevel cut. With the saw set for a bevel, the weight of the saw's body makes the saw want to fall over, thus requiring you to hold the base flat to the Guide Rail with your other hand. I know that there are a couple of comments, but I think its time to. For 399 its almost double the price of the Seneca Woodworking solution and almost three times the price of the Precision Dogs. 2) Small pieces (cut 1' off a 3' piece) are hard / dangerous to cut with a Festool TS or chop saw. Hi guys, today I got an email, that Woodpeckers Paralles Guide System (supposed to be a One Time Tool) is brought back to a second production run. Typically, when you make a bevel cut you would first make a cut at 90 degrees and then tip your saw to the desired bevel and cut again. I built a few projects using only Festool and came to the following conclusions: 1) A good table saw or bandsaw will allow faster setup and feed rates for cuts. FREE shipping Add to Favorites Guide Rail Hook / Mount / Holder for Festool FS 1400/2 kp and FS 1900/2 kp. Add to Favorites ToolCurve Parallel Guides for Festool Guide Rails and Track Saws (2.3k) 59.95. The Parallel Guide Extensions connect to the Parallel Guide (495717), enabling narrow rip cuts from 1mm to 195mm (1/16 in to 7-11/16 in). Wall Holder for both Festool Parallel Guide and Guide Extensions (134) 14.99. Compatible with any length of Festool and Makita Brand Guide Rails.Make Your Wood Working. There is, however, a situation where one might make use of the Parallel EDGE Guide while the saw is on the Guide Rail, and that is to stabilize the saw on the Guide Rail when the saw is tipped for making a bevel cut. The Parallel Guide System greatly enhances the capability of the Festool Guide Rail System by providing a faster, easier, smarter way to create consistent rip cuts. Precision Parallel Guide System for Repeatable Cuts for Track Saw. You would NOT use this Parallel EDGE Guide with the saw on the Guide Rail to guide the saw along the edge of your material, as the Guide Rail is what will dictate the saw's path. Well, yes, but NOT like you may be thinking.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |